The TCP Authentication Option (TCP-AO, RFC 5925) provides cryptographic segment protection for mission-critical routing sessions such as BGP peering across wide area networks. In dynamic routing infrastructures where key rollover occurs without session teardown, mismatched Send Key ID (SendID) or Receive Key ID (RcvID) pairs cause segment authentication checks to fail. When the Linux kernel encounters non-matching Key IDs during passive SYN-ACK verification, it silently discards segments, incrementing internal retransmission statistics while logging minimal network-layer diagnostics.
Diagnosing these stealthy authentication failures requires low-overhead kernel tracing. By extracting metrics from struct tcp_sock and correlating the tcpi_retrans_synack counter from TCP_INFO, network engineers can pinpoint transient Key ID selection drift using eBPF and bpftrace.
The Key ID Selection Dynamics in the Linux Kernel
TCP-AO headers carry explicit one-byte fields designating Key ID and Next-Key ID. During active transmission, the sender assigns the Key ID mapped to its active Master Key Tuple (MKT). Upon segment arrival, the receiver checks whether the designated Key ID matches an active receiving tuple configured on the listening socket. If the remote peer selects an unknown Key ID during SYN-ACK handshake retries, the packet is discarded at tcp_ao_verify_header().
The key kernel parameters and monitoring offsets are outlined below:
| Kernel Symbol | Source Location | Data Structure Offset | Diagnostic Purpose |
|---|---|---|---|
tcp_ao_verify_header |
net/ipv4/tcp_ao.c |
struct tcp_ao_key * |
Validates AO digest against selected Key ID |
tcp_get_info |
net/ipv4/tcp.c |
tcpi_retrans_synack |
Reports cumulative SYN-ACK retry count |
tcp_v4_rcv |
net/ipv4/tcp_ipv4.c |
skb->cb |
Traces inbound segment discard points |
Attaching bpftrace Probes to TCP-AO Verification
Run the following bpftrace script to monitor passive handshake retries and highlight Key ID selection failures in real time:
sudo bpftrace -e '
#include <net/sock.h>
#include <linux/tcp.h>
kprobe:tcp_ao_verify_header {
$sk = (struct sock *)arg0;
$tp = (struct tcp_sock *)arg0;
$dport = $sk->__sk_common.skc_dport;
// Filter for BGP port 179
if ($dport == 179 || $sk->__sk_common.skc_num == 179) {
@monitored_synacks[$sk] = $tp->retrans_out;
}
}
kretprobe:tcp_ao_verify_header {
if (retval != 0) {
time("%H:%M:%S ");
printf("TCP-AO Key ID selection failed with code %d
", retval);
}
}
END {
clear(@monitored_synacks);
}'Reading tcpi_retrans_synack via ss Diagnostic Tooling
Complement kernel probes by inspecting active socket stats using ss:
# Query active TCP-AO enabled sockets with extended TCP_INFO metrics
ss -ti 'sport = :179 or dport = :179'Examine the output for high retrans figures accompanied by stagnant RTT estimators. When correlated with eBPF tcp_ao_verify_header failure return codes, this confirms a Key ID selection mismatch across peers.