The TCP Authentication Option (TCP-AO, RFC 5925) provides cryptographic segment protection for mission-critical routing sessions such as BGP peering across wide area networks. In complex transport backbones undergoing active traffic engineering, middleboxes often manipulate the Congestion Window Reduced (CWR) bit in TCP headers to reflect congestion notification feedback. RFC 5925 stipulates that dynamic flag bits must be zeroed before generating or verifying the MAC digest. Discrepancies between peer implementations lead to immediate packet drops.
Diagnosing these stealthy authentication failures requires low-overhead kernel tracing. By extracting metrics from struct tcp_sock and correlating the tcpi_retrans_synack counter from TCP_INFO, network engineers can pinpoint transient CWR bit anomalies using eBPF and bpftrace.
The CWR Normalization Dynamics in the Linux Kernel
Under Linux, tcp_ao_verify_header() applies zero-masks across all designated dynamic flags. If an unaligned hardware offload engine failed to perform this normalization before transmitting the initial segment, verification fails at tcp_ao_verify_header().
The key kernel parameters and monitoring offsets are outlined below:
| Kernel Symbol | Source Location | Data Structure Offset | Diagnostic Purpose |
|---|---|---|---|
tcp_ao_verify_header |
net/ipv4/tcp_ao.c |
struct tcp_ao_key * |
Validates AO digest against masked CWR flag bits |
tcp_get_info |
net/ipv4/tcp.c |
tcpi_retrans_synack |
Reports cumulative SYN-ACK retry count |
tcp_v4_rcv |
net/ipv4/tcp_ipv4.c |
skb->cb |
Traces inbound segment discard points |
Attaching bpftrace Probes to TCP-AO Verification
Run the following bpftrace script to monitor passive handshake retries and highlight CWR bit verification failures in real time:
sudo bpftrace -e '
#include <net/sock.h>
#include <linux/tcp.h>
kprobe:tcp_ao_verify_header {
$sk = (struct sock *)arg0;
$tp = (struct tcp_sock *)arg0;
$dport = $sk->__sk_common.skc_dport;
// Filter for BGP port 179
if ($dport == 179 || $sk->__sk_common.skc_num == 179) {
@monitored_synacks[$sk] = $tp->retrans_out;
}
}
kretprobe:tcp_ao_verify_header {
if (retval != 0) {
time("%H:%M:%S ");
printf("TCP-AO CWR bit verification failed with code %d
", retval);
}
}
END {
clear(@monitored_synacks);
}'Reading tcpi_retrans_synack via ss Diagnostic Tooling
Complement kernel probes by inspecting active socket stats using ss:
# Query active TCP-AO enabled sockets with extended TCP_INFO metrics
ss -ti 'sport = :179 or dport = :179'Examine the output for high retrans figures accompanied by stagnant RTT estimators. When correlated with eBPF tcp_ao_verify_header failure return codes, this confirms an asymmetric CWR bit discrepancy across peers.